Difference between revisions of "PrintrBot Play"

From Bloominglabs
Jump to: navigation, search
(Added link to new, official Printrbot Play page)
(Reformatted text on reflashing firmware)
Line 4: Line 4:
  
  
----
+
==Original Condition==
Printer has been in a nonfunctional state.
+
When the Printrbot Play was donated, it was nonfunctional.
 +
On February 23, 2017, [[User:Apple | Apple]] reloaded the bootloader and firmware with:
 +
* avrdude
 +
* a USBtinyISP programmer.
 +
* the RepRap wiki page on the Printrbot's control board: [http://reprap.org/wiki/Printrboard reprap.org/wiki/printrboard]
 +
* [https://github.com/scwimbush/Printrboard-HID-Arduino-IDE-Support/tree/master/printrboard/avr/bootloaders  BootloaderHID.hex ]
 +
* [https://github.com/Printrbot/firmware-updater/blob/gh-pages/binaries/ play-0.6.hex]
  
February 23, 2017 reloaded bootloader and firmware with avrdude and a USBtinyISP programmer.
+
The controller board, firmware, steppers, and sensors seem to be working fine.
 
+
Reference  [http://reprap.org/wiki/Printrboard reprap.org/wiki/printrboard]
+
 
+
[https://github.com/scwimbush/Printrboard-HID-Arduino-IDE-Support/tree/master/printrboard/avr/bootloaders  BootloaderHID.hex ]
+
[https://github.com/Printrbot/firmware-updater/blob/gh-pages/binaries/ play-0.6.hex]
+
 
+
With an ATX power supply,  controller board, firmware, steppers, and sensors seem to be working fine.
+
  
 
Challenge now is test various filaments and to locate printer in a more permanent location with a dedicated ag150.
 
Challenge now is test various filaments and to locate printer in a more permanent location with a dedicated ag150.

Revision as of 23:48, 19 November 2017

A pre-assembled Printrbot Play (model 1505) was donated around 7 November 2016. It is one of several 3D Printers Bloominglabs has.

The complete, official documentation can be found on this Google Drive folder.


Original Condition

When the Printrbot Play was donated, it was nonfunctional. On February 23, 2017, Apple reloaded the bootloader and firmware with:

The controller board, firmware, steppers, and sensors seem to be working fine.

Challenge now is test various filaments and to locate printer in a more permanent location with a dedicated ag150.

Personal tools