Ender-3 S1

From Bloominglabs
Jump to: navigation, search

The Ender-3 S1 was procured by a member faction interested in increasing project flux within the Digital Fabrication Lab at Bloominglabs.

By upgrading our equipment (as measured according to the metric of Low Cognitive and Maintenance Overhead to Use, rather than performance simpliciter), it is hoped that more investment of attention and resources will be drawn to this sector of the space.

OEM product listing: https://www.creality.com/products/creality-ender-3-s1-3d-printer

Ender 3-S1

Printer Features

220x220x270 mm build volume

Single nozzle extruder, 0.4 mm diameter, max temp 260 C

Heated build platform, max temp 110 C, with removable magnetic surface sheet

Filament sensor.

See "Product Parameters" on the OEM page above for further information.

Mechanical bed depth sensor: used by the printer to construct a map of variations in the build platform.

Note that this printer does not auto-level: the z-offset, and build platform tensioning wheels, must be set manually. Full procedure available on the Creality FAQ page for the Ender-3 S1 (not Pro or Plus): https://www.creality.com/pages/faq

Usage Information

Please note any changes in printer functionality or settings (z-offset, manual re-levelling, firmware modification, cleaning, repairs, mechanical/electrical/software failures, etc.) in the Log below.

Please route all filament through the filament sensor, to avoid partial prints.

Known good filament: 1.75 mm diameter PLA, ABS, TPU, PETG

Log

[Please include a status report at the top of all Log entries.]

20240109:

Status: Functional

Printer assembled, bed leveled, z-offset set to -3.15 mm, first test print.