View source for Building Committee 2017

This is a page to organize our relocation in 2017.


== Things we have currently ==
* $4 per square foot
* 3200 square feet
* Excess parking
* Easy access to B-line trail
* Clean room area / hangout area
* Workshop area
* Garage door
* RFID access
* 


== Potential Space Candidates ==
* South Walnut location
* South Rogers location
* Downtown location/Kiln building
*


== Things we Need ==
This assumes basic minimums of a usable property are met such as non-leaky roof, working HVAC, cold+hot water, etc.

* ~$4 per square foot
* 3000 square feet minimum
* Enough parking
* High-speed internet access
* Clean area
* Workshop area
* Ability to support RFID door access system
* 200A service minimum for our area, more is better though
* Ability to install through-exterior-wall vents for laser (minimum), also for welding and laboratory areas if possible
* 


== Things we Want ==
* Access to B-line trail
* More space
* Garage door
* Area for car lift
* Isolated wood shop and metal shop areas
* The ability to get more space as we grow
* Ability to mount antennas, weather station, etc. on the building or on the property
* Access to our own breaker panel
* Ability to run cables through walls (RFID, ethernet, CCTV (coax), etc.
* Sound insulated area for air compressor and dust collection system
* Pneumatic lines ran from compressor to useful areas in wood shop, metal shop, labratory, etc
* Ceiling hung retractable extension cords in workshop('s) - we have a number of these ready to be installed
* 


== Materials from current building which belong to Bloominglabs ==
Mid-wall refers to the long wall that divides the office from the workshop.

* water heater - belongs to Dale Myers, he may want it back
* window AC unit
* emergency exit lights over front and rear doors
* paper towel dispensers
* exterior exhaust vent louvres
* all door knobs installed in building, originals should be in a safe place
* RFID system, including electric strikes installed in both door frames
** Might be worth replacing these, ours are cheap and known for wearing out
* server room framed door, mid-wall framed door
* all cat5 in building
* AC wiring (romex) in mid-wall, oulets, boxes, etc.
* AC wiring around exterior walls of the workshop, stopping at the rear door
* AC sub-panel and all wiring, conduit, outlet, etc. feeding the air compressor
* all 220v outlets in workshop
* all lights on ceiling minus four of the 8' fixtures in cluding wiring
* motion light outside garage door
* light sensor for front door light
* Bloominglabs sign above our front door
* all exterior antennas and related grounding wires
* interior signs hung from ceiling
* all shelves attached to walls
*